Common fault problems in the use of curved line edge banding machine

               
Update: 09-05-2020
               
Abst:

Some problems and faults will also occur in the use of […]

Some problems and faults will also occur in the use of curved line edge banding machine. Common faults are:
1. Electrical failure. Including the main engine stalling, unreasonable temperature rise, disordered procedures, etc., if not eliminated in time, it will burn the motor and heating tube, or even damage the entire mechanical system. Mainly check the electrical control box, motor, heating tube, delayer, etc. during maintenance. Such overhauls are generally repaired by professionals or by manufacturers.
2. The gas path is faulty. Including air valve failure, air leakage, low air pressure, cutting knife, feeding does not work, etc., mainly check the integrity of various pneumatic components, replacement parts can be carried out under the guidance of the manufacturer's technical staff.
3. Mechanical failure. Mainly include transmission failure, uneven coating, feeding failure and cutter failure, etc. Mainly check the intact condition and firm parts of each mechanical part, whether the transmission parts are shifted.
4. Bonding failure. Such as inability to stick, deviation, entrainment, etc., this is a comprehensive fault and is related to the rubber shaft, edge band, sol, substrate and operation. Such failures may occur alternately or singly, and the specific maintenance depends on the situation.
The above four points are the common fault problems in the use of curved line edge banding machine.

www.bettnmac.com

0
Contact Us